At some point, you may accidentally drop your iPhone Data Recovery Services in water. If this situation occurs, there are ways you can use to save it. To begin with, there are six things that you should do immediately your iPhone has water contact. They are:
Remove from water as soon as possible.
Turn the device off.
Disconnect an accessories like USB cables, chargers, ports or headphones.
Any enclosure or case should be removed immediately as they may trap in moisture.
Dry the iPhone as best as you can. At this point, you can use any piece of clean cloth.
Remove any moisture from the small crevices such as the audio out jack.
Once you have followed each of the following steps, you should now put the device in a rice bag. For this to work, you will need an airtight bag such as a zip-lock bag, rice (make sure it is the generic and not the ‘enriched’ type of rice) and patience. Fill the airtight bag with rice so that the entire iPhone will be covered in rice. Now place the iPhone in the bag and seal it shut. Make sure there is some air in the bag when you seal it.
Take note that even though any type of rice will work, you should avoid enriched rice. The reason why this type of rice is not recommended is that it will leave white residual Data Recovery Services powder in the bag as a result of whatever makes sit enriched. The same residual powder will get into the buttons and ports of your iPhone. To avoid these issues, just go and get a bag of normal rice if you do not have the same in your home.
The patience part is the hardest of all. The fact of the matter is that the longer you wait the better the outcome since you will need to ensure all the water in the device has been completely absorbed by the rice a few hours before you try to switch it on. The minimum duration should be at least 24 hours. For the best outcome however, it is advisable to leave for about 48 hours. If you are not a patient person, you should find an alternative phone you can be using while your iPhone is drying. This way, you will not be tempted to start using it before it is completely dry.
The moment you have waited for about 36 hours, you can open the bag of rice and check your phone. If you suspect the device has any residual moisture left in, you should not power it on. If everything seems to be working well, you should turn it on as usual. If you followed the instructions above, your iPhone Twitter Data Recovery Services should power on and work the same way it did before it got water contact.
In some cases, you may find that the device was in water for are an extended period of time. If this is the case, it will have powered off on its own. In such a scenario, it would be prudent to take it to a mobile phone repair technician. Though this is not a guarantee that it will work again, they may be able to salvage your phone depending on the amount of water damage.